Dediprog SF600 SPI Flash Programmer
On- and Off Site
Do In and Off System Programming
The SF600 is a high speed "in System Programming" programmer to update the SPI Flash soldered on board (In Circuit Programming) or in the socket adaptor (Off line programming). The programmer is easily controlled by the included Software through the USB bus offering friendly interface and powerful features to users.
- USB High speed and high SPI performance, support up to 1Gb SPI Flash
- In circuit Programming: Program on board SPI Flash
- Off line Programming: Program SPI Flash in the socket
- Support Single, Dual and Quad IO serial communication (new serial Flash protocol)
- Program two Serial Flash memories
- Start button feature: Can do Batch function in USB mode
- Signal conflict protections
- Multi-Programmers Capability through USB
- Support 1.8V low voltage IC
- Support Windows 2003 and above
- Support both 32 and 64 bit OS
Engineering Graphic User Interface
For engineers and expert to access advanced features for development, repairing etc.
Production Graphic User Interface
For operators in production to control multiple programmers and improve the throughput.
Command line interface
Customer software can control the multi SF600 programmers (SF600 integration, Control SF600 with Production In Circuit Tester.)
SF600 is designed with ISP header, through an appropriate connector, users can connect the programmer and drive the SPI signals, supply the memory and control the controller or application status. Please refer to Table 1 for the SF600 2x10 header pin out. DediProg also provides the SF600 ISP Cable which is used to connect the SF600 programmer to the 2X6 2.54mm ISP Pin Header on board, please refer to Table 2 for the SF600 ISP Cable 2x6 pin out.
Hardware Requirement for ISP
To have a clear understanding on the different ISP or backup boot methods and different reference schematics, please download our dedicated application notes: AN0103 and AN0106 in the documentation section.
|Support all Serial Flash||Yes|
|USB Full speed||No|
|USB High speed||Yes|
|In Circuit Programming||Yes|
|Off line Programming||Yes|
|Stand Alone mode||Yes|
|Backup Boot Flash||Yes|
In the box
- 1 x SF600 Programmer
- 1 x USB Cable
- 1 x ISP Cable (ISP-600-CB1-G)
- 1 x SF100 2.54mm 2*4 ISP Cable (ISP1-CB)
- 1 x SF600 Universal Adaptor (ADP-SF600-TO-SF100)
- 1 x CD-ROM (Included Software, specifications and user manual)