Total Phase 34-Pin: 10-Pin Header Cable
34-Pin to 10-Pin Header Cable
This is a replacement cable for the Promira Serial Platform. The 34-pin end has a locking friction ramp to ensure good connectivity with the Promira Serial Platform, while the end is a 10-pin, 5x2 0.010" standard header.
This cable has a 34-pin connector to attach to your Promira Serial Platform on one end, a 10-pin box header that attaches to your project.
This cable is backwards compatible with the I2C/SPI Activity Board, the CAN/I2C Activity Board Pro, and the High-Speed SPI Flash Demo Board. It can be used with the 10-Pin Split Cable and the 10-Pin Grabber Clip Split Cable.
- Don't have space for a 5x2 0.100" header on your test board?
- Want to make use of a header that doesn't have the same pin-out as the Aardvark I2C/SPI Host Adapter ribbon cable or the Beagle I2C/SPI Protocol Analyzer ribbon cable or the Promira Serial Platform?
- Don't want to create an adapter board to interface with your target?
The 10-Pin Split Cable and the 10-Pin Grabber Clip Split Cable are the ideal solutions for you.
For more advanced or power intensive applications, the 34-pin cables are recommended because they provide additional connectivity to your project, enabling features not available with the 10-pin cables. Please note, specific pins and functionality are determined by the applications licensed on your Promira Serial Platform.
The project side connector is a standard 5x2 0.100" (2.54mm) pitch IDC type keyed box connector. The cable is only 5 inches (12.7cm) long to minimize signal degradation.
The 34-Pin Header Cable has a 34-pin box header that attaches to the Promira Serial Platform. The connector is a standard 2x17, 0.079 inches (2.00 mm) pitch IDC type keyed box connector. The cable is only 6 inches (15.2 cm) long to minimize signal degradation.
In the box
- 34-Pin to 10-Pin Header Cable