I2C Mode
Function:
Produce and transmit the data of I2C, and simulate the state of the Master or Slave.
Features:
- The Bit Rate of I2C Signal can be set as users' requirements (range from 2KHz to 833KHz).
- Support 10 Bits Address.
- Support transmitting the data of I2C continuously (No Stop) and the Combined Format.
- Support I2C Trigger function, that is to say, the state of the data of I2C can be set as the Trigger Condition according to users' requirements.
I2C Monitor
Function:
Monitor the State of Read/Write, Address and Data Packet on the Protocol Analyzer I2C.
Features:
- Record all packets in the Protocol Analyzer I2C continuously.
- Include the State of Read/Write, the number of the Address and the contents of the Data Packet.
- Save the recorded results by way of the EXCEL File mode.
SPI Mode
Function:
Generate, transmit, simulate and analysis SPI signal (Master/Slave side)
Features:
- The Bit Rate of SPI Signal can be set according to users' requirements ( the range is from 158KHz to 1000KHz).
- Adjust the SPI Mode (Phase/Polarity).
- Support SPI Trigger function, that is to say, the state of the data of SPI can be set as the Trigger Condition according to users' requirements.
GPIO Mode
Function:
Set the state of the 8bits Data according to users' requirements, which is required to be produced.
Features:
- Set the 8 Pin Mode or 6 Pin Mode.
- Match the GPIO Mode with the I2C Mode or SPI Mode to use.
- Adjust the IO Pin to judge whether the Pull-Up Resistance needs to be added.
Batch Mode
Function:
Support the I2C, SPI and GPIO Modes, and deal with the data to be produced in the Batch Mode.
Features:
Define the state of the Data Transmission flexibly and simulate the reaction of the actual device through the Batch Mode.
| 
